RGTT Hybrid REGA Custom Turntable & Rare Manticore Tone arm

Up for sale is a gorgeous custom made (Canada) turntable and arm that was built with an upgraded
brand new Delta device acrylic platter, Alloy sub platter, Stainless steel
pulley, Ruby red belts (2 each) and Ruby red bearing. The motor is that used in
REGA P3 turntables.

The table comes with a rare find Manticore Magician tonearm in best condition with Cardas DIN plug terminated with RCA connectors to enjoy variety of interconnects you
wish to use.

The 40 lb multi-layered plinth is wrapped with exotic Birdseye Maple and Bombay Mahogany
stained cherry veneer. Take note of the natural wood grain imperfections near
the sub-platter & screw marks on head shell. The plinth is clear coated and
buff to high gloss finish. I will include an extra blank arm board as shown.

I purchased this unit in October 2016 NEW but it’s been sitting for several months due to
lack of listening time. Please note the damaged corner – this corner is LOWER-REAR-LEFT and cannot be seen at all when standing in front of the
table. The damage occurred when it was shipped to me at time of purchase. Perhaps
you know a wood worker as it won’t take much to repair. I have taken this blemish
into consideration in the pricing.

This table plays smooth, slightly warm with excellent detail and is VERY quiet. Surface
noise is almost non-existent. Use a “good” cartridge and you’ll experience the
same. Extension up & down the dynamic range is very nice, balanced and with tight bass.

I will also send an EXTRA tonearm board, should you wish to change the tonearm
down the road. Power chord included and I have an electronic copy of the
Manticore manual.

This RGTT collection is Sold AS IS. NOTE: A cartridge is not included. Buyer pays a flat rate shipping. THANK YOU for looking.