Monarchy Audio SE-100 Delux Mark 2 Monoblock Amplifiers

This pair of Monarchy Audio SE-100 Delux Mark2 monoblock amplifiers have just gone through a factory upgrade. Physically they sport the same basic look as their predecessor, except for oval handles on the front plate, laser engraving on both front and rear panels as well as twice the amount of vented slots on the top cover. The extra ventilation is always welcome as these100-watt at 8 Ohm (200-watt at 4 Ohms) single-ended Class A amplifiers run a bit warm to the touch, as is quite normal with Class A amplifiers. They also still sport both single-ended and balanced inputs plus an IEC connector so you may experiment with different power cords.
On the insides, they have gone through some changes as well. With the use of improved layout and wiring techniques to reduce hum, a time-delay relay to eliminate turn-on thumps and positive over-drive protection for clean clipping, we now have an amplifier that is much quieter than previous versions. The MK2's are also more stable and rated to handle difficult loads down to 2ohms. 

Specifications Type: Monophonic solid-state amplifiers (pair) Output Power: 100 watts into 8 Ohms Inputs: Single-ended via RCA  and Balanced via XLR Protection Fuses: Three Front Panel: 9 x 12 x 4 (WxDxH in inches) Net Weight: 25lbs each
These sweet-sounding monoblocks only have a couple of hours on them and aren't even broken in. As it turned out, while I was waiting for these to come back from Monarchy, I changed up my system (typical audiophile) and went a different direction. 
Brand new boxes and power cords included.