DYNACO MK III STUNNING!

COMPLETELY Rebuilt Dynaco MK III amps
STUNNING!
In my opinion there is no more beautiful amplifier, form follows function
Selling as I have to many amps
I did not build these to resale, Or to save money on parts, used the best available
Cost was much more than price, less labor
But if I keep them it wont hurt my feelings
Possible trade for NICE Pre-amp
Klyne, ARC etc Tube

New everything, But the Original Transformers, The early transformers were wound by hand in the USA. Then the transformers underwent a part number change and were outsourced to Japan for manufacture. Even later versions of the output transformers had a part number change again The original output transformers (Dynaco with cloth covered leads) are fantastic transformers. This is one good iron. You would be hard pressed to find anything better even today, some 40 years later (you see, some things just can't be improved upon!). Transformers are rubber Isolated,Reduces mechanical generated “HUM” and noise Painted with High temp Hammered finish, Stainless steel hardware, Neoprene Grommets, red fiber washers ( Like lipstick on a woman)
Chassis are Powder coated (Silver Vein)
Stainless steel hardware,
Poseidon PCB ,1 12ax7, 1 12au7 tubes, individual Power Tube bias
Quad cap replaced with Extra beefy cap
Rhodium Binding posts.
Rubber Transformer iceolators
Tube sockets are Silver plated ceramic
6' retractable power cords
Silver / teflon wiring, Silver solder
I'm sure I have left some things out of the description but every detail was addressed when I built these amps and Most important,
THEY SOUND REMARKABLE!
Supplied with a complete NOS Tube set
(4) NOS Svetlana, Winged C St,Petersberg 6550's 1990's
(2) NOS Mullard Gz 34's Rectifiers 1960's
(2) EI Prewar 12ax7 Telefunken Tooled
(2) EI Prewar 12bh7a Telefunken tooled
800.00 alone

Specs:

CIRCUIT TYPE: PUSH-PULL DESIGN (MONO AMP)
POWER OUTPUT: 60 WATTS RMS
TUBE TYPES: (2) 6550 OR KT88 OUTPUT TUBES
(1) 12 ax7 (1) 12 au7 INPUT TUBES
(1) GZ34/5AR4 RECTIFIER TUBE
INPUT SENSITIVITY: 1.5V FOR 55 WATTS OUTPUT
INPUT IMPEDANCE: 470K OHMS
OUTPUT IMPEDANCES: 4, 8 OHMS
NOISE & HUM: MORE THAN 90 DB BELOW FULL RATED POWER
THD: LESS THAN 1% AT FULL POWER
FREQ. RESPONSE: 20 HZ TO 20K HZ AT FULL POWER + / - 1 DB
POWER SOURCE: 120 VAC 60 HZ @ 180 WATTS (MAX)
SIZE: 6 ¾" H X 9" W X 9" D
WEIGHT: 28 Lbs.

Please contact me with any Questions
Oh yes, Original Cages are included
And Manuals
I will cover shipping and paypal fees
All the best,
Mark